ConnecTite joints are over 20 times faster to install than a solvent cement joint.

Thanks largely to the market’s familiarity with push fit pressure fittings, the installation is rather intuitive.

ConnecTite fittings have no cure time. In comparison, a 2” solvent cement joint has a minimum cure time of two hours before it should be tested.

This allows a DIYer to quickly complete their DWV project with ConnecTite fittings and then spend their time doing something more enjoyable.

For a repair plumber, they can move on to their next customer in a fraction of the time, thereby increasing their revenue.

Better for human health and safety

More environmentally friendly – ConnecTite contains no Volatile Organic Compounds (VOCs).

Eliminates confusion over which solvent cement to use

Eliminates the hazardous waste disposal of out-of-date cans of cement and primer

No mess – Spilling purple primer is almost inevitable, especially for a DIYer. When this happens, there is no way to clean it up. This is of particular concern if you are making a solvent cement joint in a finished area.

With a ConnecTite fitting you can simply twist the fitting into proper alignment.

This is helpful when you are using a fitting with a bend (90° Elbow, 45° Elbow or Sanitary Tee).

If you have a misaligned fitting with solvent cement, the only option you have is to cut out the joint and start completely over.

If pipe is cut too short or too long, you can remove the pipe from the ConnecTite fitting, cut your pipe to the correct length and then reuse the same ConnecTite fitting up to three times.

Again, with solvent cement your only option is to cut out the joint and start completely over.

ConnecTite fittings can be used as a transition fitting as it works with Schedule 40 OD plastic pipe.

Unlike push fit pressure fittings, ConnecTite fittings do not require a tool for reversal.

ConnecTite fittings will fit in the same places as a solvent cement fitting of the same diameter.

Like all Charlotte Pipe products, ConnecTite fittings are made in the USA.